info@relchip.com LI FB

High Temperature Standard Products

DS1

RC10001DB Development System

The development supports code development for the RC10001. System hardware comes complete with a USB/Serial Wire Debug interface, interface board, and the main board including the microcontroller, activity LEDs, and interrupt generation switches.

  • Development System Board
    • Microcontroller Populated
    • Microcontroller Power Switch
    • Reset Control
    • LED Display for GPIO0 Activity
    • Two Interrupt Initiators
    • Two Sockets for Optional External RAM
  • Interface Board to PC USB
  • Cabling
  • Software including Examples
RP1 AC1

RC10001 32-Bit Microcontroller

The RC10001 microcontroller includes a 32-Bit processor, on-board memory, and multiple boot options. The RelChip RC10001 microcontroller uses an ARM® Cortex® M0 core. The microcontroller includes standard serial interfaces, four timer/counters, and a nested vector interrupt controller. The design is fully static, with deterministic operations. These parts all operate from -55°C to 300°C on a single 5 volt supply.

  • ARM Cortex-M0 Core with Thumb®-2 Instruction Set
    • 32-Bit Internal AHB and APB Data Bus
    • 32-Bit Single Cycle Multiply
    • NVIC Interrupt Control (with Determinism)
    • 21 Maskable Interrupt plus 6 Non-Maskable
    • System Tick Timer
    • Internal Boot ROM
    • Serial Wire Debug Port
    • Breakpoints and Watch Control
  • Programmable Watchdog Timer
  • Internal SRAM (Code and Data Storage) with Battery Back Up
  • External Memory Bus Expansion
  • 90 Programmable GPIO
    • Input/Output/Interrupt Input
    • Programmable pull-up and pull-down
  • SPI Interface
    • Configurable as master or slave
    • SPI™, SSI, and Microwire™ Compatible
    • Internal FIFO
    • Programmable Phase and Polarity
  • UART
    • RS232 and RS485
    • 16550 Compatible Registers
    • Internal FIFO
    • Interrupt Masking
  • Clocks
    • Crystal
    • External
    • Programmable System Clock Division
    • Programmable Peripheral Clocks
    • Clock Output
  • 4 Counter Timers
    • 2 16-Bit and 2 32-Bit, Both Prescale and Count
    • 4 Level, Edge, PWM, and Non-Overlapping Match Outputs
    • Programmable Reset and Interrupt Matches
    • External Clock or Capture Input
  • Real Time Clock
  • Power Management
    • Power On Reset (POR)
    • Reduced Power Modes: Sleep, Deep Sleep, and Deep Power-Down
    • External Wake Up Interrupt
RP2

SRAM Family

The RelChip RAM family includes many popular interfaces and functions. These parts all operate from -55°C to 300°C on a single 5 volt supply. All parts support a separate battery back-up supply. There are serial, 9-Bit, and 36-Bit interfaces that support parity. Parity is stored when written, and checked when read.

  • 32Kx9 SRAM
  • Multiplexed Address/Data Bus
  • Parity Selectable
  • 8Kx36 SRAM
  • RC10001 Compatible
  • Parity and Burst Mode Selectable
  • 32Kx9 SRAM
  • RC10001 Compatible
  • Parity and Burst Mode Selectable
  • 32Kx8 SRAM
  • 8051 Compatible
  • 32Kx9 SRAM
  • Separate Address/Data Pins
  • Parity Selectable
  • 288Kx1 SRAM
  • SPI Interface
  • Multiple Operating Modes
  • Supports Page Operation